2. Installation and preparing for use
2.1 Unpacking and checking of the unit
Check the integrity of the packaging to exclude damages occurred during transport. Check the entirety of
the equipment and of the relevant accessories. Not conformities, if any, have to be pointed out immediately
and written down on the transport documents
2.1.1
Checking the accessories delivered with the unit
2.2 Preparing for use
2.2.1 Removal of load cell blocking device
Before using the unit for the first time remove the safety screw which is screwed to the tank load
cell for protection during transport(see fig. 1). It is recommended to check the regular functioning
of the load cell, for example by hooking a known weight to the bottle to check the corresponden-
ce with the weight shown on the display (see relevant paragraph).
1
Rivet nut to fix the load cell during transport
2
Threaded hole to fix the calibration hook to the
load cell
3
Fixing bolts of the load cell
2.2.2 Oil level checking of vacuum pump
Check the level of hydraulic oil in the vacuum pump and, if necessary, fill up to the level (about half of the
spy glass)
Ecos-150 sw 1.x.x - ver. 1.0
Page 5/20
Half of the level
