lower the pulley to be in-line with the larger pulley. Tighten the screw, place the
belt onto the pulleys, and test by spinning the large pulley by hand. If the belt
stays on both pulleys it is aligned properly.
If the seamer does not turn on
, it may be because either the thermal overload
switch (located on the bottom of the motor) or circuit breaker (white button
located on the backside of the electrical box) has tripped. You will need to
remove the seamer’s back cover to access the motor’s thermal switch. The circuit
breaker is a white button on the bottom of the switch housing. Pushing either of
these reset buttons in will reset them.
One common cause for them tripping is
pulling both operation levers at the same time.
Summary of Contents for 7
Page 4: ...MODEL 7 SEAMER DIAGRAM...