4345-E P-18
SECTION 4 MACHINING REPORT DISPLAY
4.
Output to Floppy Disk
Eeospkku4004
You can save the machining report displayed on the screen by outputting it to floppy disk.
(1) Insert an MS-DOS format floppy disk to the floppy disk drive. The machining report displayed
on the screen is output to the floppy disk.
EIOSPKKU4008R01
(2) The machining report displayed on the screen can be output to the floppy disk by simply press-
ing function key [F6] (
File). The device name and the file name are set at the MacMan
parameters displayed in the parameter setting mode.
•
Device name
The machining report is output to the device set at DEFAULT DEVICE. The initial setting for
DEFAULT DEVICE NAME is "FD0". Therefore, to output the machining report to a floppy
disk set in the FD0, you do not have to set the output device name.
•
Output file name
The machining report to be output to the floppy disk is assigned the file name which is set at
DEFAULT FILE of the MacMan parameter displayed in the parameter setting mode. The ini-
tial setting for DEFAULT FILE NAME is:
If today is April 12, 1999 and the previous day is April 07, 1999, the actual file names to be
assigned are:
(3) If you output the machining report to the floppy disk (MS-DOS format), it is output in the text file.
Refer to Section 19. "OUTPUT FILES".
•
If the report information is output in the text file, it can be displayed or analyzed using word
processor software.
Daily machining report file
DW*Y*M*D. TXT
Period machining report file.
TW*Y*M*D. TXT
Daily machining report (today)
DW990412. TXT
Daily machining report (pre day)
DW990407.TXT
Period machining report
TW990412.TXT
