Setup Instructions
STANDROID
Frame and Fabric
Connecting the Frame
Installing the Fabric (F)
1. Connect 3-part Vertical Supports (A) with
plastic grommets facing out.
2. Using the Hand Tool (B), attach the top
and bottom Horizontal Supports (C) to the
Vertical Supports (A) by turning the screw
with the star-shaped hole clockwise.
PLEASE NOTE : Make sure the thin
groove is along the outer edge of
each piece so the groove is continuous
around the frame.
3. Using the Hand Tool (B), attach the Cross
Supports (D) in the same manner at the 2
joints in the Vertical Supports (A). PLEASE
NOTE: The 3rd Cross Support (D) is
included for added support or for use as a
spare replacement piece.
1. Make sure the frame is laying flat on the
floor and the star-holed screws are
facing down.
2. Start with each corner and attach Fabric (F)
by rolling fabric in and pushing the rubber
beading into the thin groove along the edge
of the frame with your thumb.
3. After the corners are secured, continue
pushing the rubber beading into the groove
along the sides, top and bottom of the frame.
PLEASE NOTE: The corners of the
stitching should be at the corners of the
frame. PLEASE NOTE: Overstretching the
fabric will result in uneven bunching of the
fabric. Pull the fabric just tight enough
to lay flat.
Connecting
Corners
Using the hand
tool
B
Connecting
middle cross
supports at
seams
D
C
A
A
C
D
2
3
