5699-E P-53
SECTION 4 INSPECTION, MAINTENANCE AND ADJUSTMENTS
2-2.
Lubricating Oil Specification
ISO viscosity grade: 2 mm
2
/S (40
°
C) or equivalent
Note
Application
Code
Shell
ExxonMobil
Kyodo Yushi
Headstock Gearbox
CKB32
Shell Tellus Oil C32
Mobil DTE Oil Light
-
Spindle Bearing
Lubrication Unit
FC10
Shell Tellus Oil C10
Mobil Velocite Oil No.6
-
Centralized Slideway
Lubrication Unit
(M-Turret, Ball Screw)
G68
Shell Tonna Oil S68
Mobil Vactra Oil No.2
-
G220
Shell Tonna Oil S220
Mobil Vactra Oil No.4
-
Hydraulic Unit
HM32
Shell Tellus Oil S32
Mobil DTE Excel 32
-
M-tool Holders
(Grease)
-
Mobilux EP2
Multemp PS No.2
Headstock Cooling Unit
FC2
Shell Tetra Oil 2
Mobil Velocite Oil No.3
-
Turret, Ball Screw
XBCEA2 Alvania EP Grease 2
Mobilux EP2, Unirex N2
-
ATC Cam box
CKC150
Shell Omala Oil 150
Mobilgear 600 XP 150
-
Oil-mist, oil-air lubrication
of spindle bearings
CKB32
-
Mobil DTE Oil Light
-
Master Jaw on Chuck
(Grease)
Molykoat EP grease (Dow Corning) or Kitagawa chuck grease for
Kitagawa power chuck.
For special chucks, refer to the instruction manual supplied with the
chuck.
•
The above table is based on the JIS B6016-1 (ISO/TR 3498) standard.
Since we do not have any experience in using the oils other than those indicated bellow,
selection should thus be made from them. Because slideway lubricating oil contains
additives such as extreme-pressure additive, it could incur variety of troubles if reacting
with other oils or coolant. Therefore, pay special attention to the use of slideway lubri-
cating oil.
Headstock Gearbox = Mobil DTE Oil Light (ExxonMobil)
Spindle Bearing Lubrication Unit = Mobil Velocite Oil No.6 (ExxonMobil)
Centralized Slideway Unit G68 = Shell Tonna Oil S68 (Shell)
Centralized Slideway Unit G220 = Shell Tonna Oil S220 (Shell)
Hydraulic Unit = Mobil DTE Excel 32 (ExxonMobil)
M-tool holders = Multemp PS No.2 (Kyodo Yushi)
Headstock Cooling Unit = Mobil Velocite Oil No.3 (ExxonMobil)
Turret, Ball Screw = Mobilux EP2 (ExxonMobil)
Oil-mist, oil-air lubrication of spindle bearings = Mobil DTE Oil Light (ExxonMobil)
•
As for service point or amount of lubricating oil of the machine, refer to the Instruction
Manual of respective machine models.
•
Lubricating oil used in common with coolant or lubricating oil used in common with
hydraulic oil might cause corrosion of lubrication unit or turbidness of oils to result in
lubrication failure, which, in turn, leads to damages on the slideway surface or ball
screw. (We take no responsibility for the troubles caused by using the lubricating oil
which is not our recommendation.)
•
As for oil replenishment for the optional accessories such as special chucks or chip
conveyor, refer to the Special Instruction Manual supplied with individual accessories.
