Page: 9
1 • Fuse:
Slo Blo fuse. Replace only with recommended value stamped on the back of your
amplifier. Failure to comply with the recommended value could seriously damage the unit.
2 • Power Inlet:
Inlet for the 3 prong power cord. Your amplifier is designed to use 120VAC.
Using any other voltages will seriously damage the amplifier.
3 • Main Speaker Jack:
Connect the main amplifier speaker to this jack.
4 • External Speaker Jack:
An external speaker can be connected to this jack.
Note -
A speaker must be connected to one of the speaker jacks at all times. Failure to do
so will result in serious damage to the unit. The combined speaker load of the main and
external speakers should not exceed 4 ohms.
5 • Impedance Selector:
Set the impedance selector to match the impedance of the at-
tached speakers.
6 • EF86 Pentode / Triode Switch:
Allows the player to select between full and half power
output for the EF86 on Channel 1. Do not change power settings unless the amplifier is in
Standby Mode.
Rear Panel: Controls And Features
EF86
Pentode
Triode
