39
6.3.4 REPLACING A FUSE
If a fuse is damaged the engine will immediately shut off, the mowing
deck will stop and all indicator lights on the dash board will turn off.
In this case it is necessary to find the faulty fuse and replace it with
a new one. Under no circumstances should you replace a faulty fuse
with a fuse that has a higher current rating!
}
Release the screw holding down the front hood, lift the hood and
remove the protective fuse cover.
}
Remove the old fuse and insert a new fuse with the same value as
the initial fuse, i.e. 20 A or 10 A.
If even after replacing the fuse the engine or the mowing deck will not work, contact an
authorised service centre.
Under no circumstances should you attempt to remove the control unit of the
electrical system!
6.3.5 LIFTING THE MOWER
If you wish to lift the riding mower, use a jack and supports.
Proceed as follows:
}
Place the jack underneath the gear box on the rear axle and lift the rear part of the mower.
}
Insert two supports underneath the ends of the axles from the inner side of the rear wheels.
}
Lift the front part of the mower and insert two supports under both ends of the front wheel axles.
Never lean the mower to the side where the carburettor is located. Oil could enter the air
filter!
6.3.6 MOWING DECK – CHECKING AND MAINTENANCE OF THE MOWING BLADES
Before each use of the riding mower check the condition of the blades (damage, wear, condition of the
cutting edge). If the blades are blunt, bent or broken it will negatively affect mowing quality. Damaged
blades are very dangerous.
A part of the material could break off and be deflected from the work area of the mower.
Whenever handling the mowing blades, always use heavy-duty work gloves.
REPLACING BLADES
If due to frequent use the blades are worn or damaged, they cannot be balanced or sharpened properly,
it is necessary to replace them immediately.
The blades are sharpened from both sides so in the event that one side is blunt, it is possible
to turn the blade around.
Always completely replace both blades and use new M16 lock nuts for attachment. This will
ensure that the mowing deck is balanced and that the blades are securely attached. Proceed as follows:
Summary of Contents for APACHE 92 EVO
