Figure 5
8
7
OIL FILLING PROCEDURE
NOTICE
WARNING
The buffer must be vertical and fully extended before filling with oil.
CAUTION
Take care when handling the oils. Observe the oil manufacturers recommendations.
DO NOT overfill past the maximum dipstick mark.
If this occurs, then oil must be removed from the buffer.
1
Unscrew the airscrew, remove from the buffer and
keep safe. (
GREEN
in
Figure 5
).
2
Unscrew the dipstick, remove from the buffer and
keep safe. (
GREY
in
Figure 5
).
3
Gradually fill the buffer with oil until the oil level is
visible between the minimum and maximum
levels on the dipstick (indicated on
Figure 4
).
4
Allow the buffer to stand for a minimum of
30 minutes.
5
Re-insert the dipstick
DO NOT
screw down.
6
Remove dipstick and inspect level. The oil level
needs to be between the minimum and maximum
marks indicated on the dipstick as shown in
Figure 4
.
7
Once oil level is correct replace airscrew and
securely fasten.
8
Once oil level is correct replace dipstick and
securely fasten.
The oil must be within the correct operating range for the buffer to perform
correctly. If further oil is required after checking repeat steps 1-8.
