Page 45
DH1 BASE UNIT / DH2 WIRELESS GATEWAY
USER GUIDE
11.
Right-Click over Highlighted Area and Select Poll Modbus Register(s)
12.
Look at Value Column for Details
13.
Troubleshooting
a.
“
- -
“
indicates the Gateway’s Config port is set to Debug mode – change
to Slave mode, then update Gateway and re-poll registers
b.
“0” indicates the Gateway’s holding registers are empty. Wait until fresh
data is collected before re-polling registers
22.
DEBUG MODE
BreeZ® Software allows users to view debug information from Gateway for
advanced diagnostic verification.
To use this mode, the Gateway must be set up in Debug mode.
Modbus polling or writing feature using BreeZ® will be disabled.
1.
Follow Instructions in Section
21
for Configuring the Gateway Config
Port for Debug mode.
2.
Click on Output Debug Tab and Information
Controlled Copy
