Page 17
DH3 WIRELESS GATEWAY
USER GUIDE
12.
GROUNDING BEST PRACTICES
1.
DO NOT
tie earth ground the digital and power ground terminals
Wireless Gateways.
2.
The panel enclosure must be grounded to earth.
3.
It is safe to mount OleumTech Wireless Gateways to panel enclosure
since the chassis and digital/power ground terminals are isolated.
4.
Where bulkhead (black phantom) antennas are used, the inner
surface, outer surface, and inner wall of the hole drilled, should be
isolated from the antenna.
Use the rubber washers supplied by
manufacturer to isolate the antennas from the enclosures
(use
thickest washer supplied by manufacturer to isolate the antennas
from the enclosures (use thickest washer on exterior side of
enclosure).
TERRE DES MEILLEURES PRATIQUES (Françias)
1.
Ne pas attacher TERRE les bornes de masse et de puissance numériques
sans fil Passerelles .
2.
Le boîtier du panneau doit être mis à la terre .
3.
Il est sûr de monter OleumTech Wireless Gateways au boîtier du panneau
depuis le châssis et les terminaux / sol de puissance numériques sont
isolées.
4.
Où cloison ( Phantom Black ) antennes sont utilisées , la surface intérieure ,
la surface extérieure , et la paroi intérieure du trou foré , doit être isolé de
l'antenne . Utilisez les rondelles en caoutchouc fournies par le fabricant
pour isoler les antennes des enceintes (utilisez la plus épaisse rondelle
fournie par le fabricant pour isoler les antennes des enceintes (utilisez la
plus épaisse rondelle sur côté extérieur de l'enceinte ) .