Page 41
DH3 WIRELESS GATEWAY
USER GUIDE
21.
CONNECT TO DH3 FUNCTION IN BreeZ®
When a DH3 is connected to BreeZ® Software, users can also directly
access the settings stored on the device. In BreeZ®, we call this
“connecting to device.” Once connected, there are a variety of actions that
can be performed such as checking Firmware version, exporting data log,
RTU and Ethernet port settings, and changing date and time.
see sec 19
for DH3 authentication
1.
To perform this function, DH3 must be powered and connected
to BreeZ® (Mini USB or Ethernet)
a.
Connecting to device shows the current setup of DH3 only.
b.
To change DH3 settings, you must access the properties by clicking
“E” button or using edit command, then re-updating the DH3.
2.
Click on Gateway in Project Tree and Click “Connect” Button
3.
Device Tab
a.
Displays how the device is set up
b.
Displays Firmware version
c.
Verify RF Security settings
4.
RTU Port Tabs
a.
Displays how the RTU ports are set up
5.
Ethernet Port Tab (How to Find IP Address)
a.
Displays how the Ethernet port is set up
b.
This window provides access to network address information
