4. Debugging
4.1
Control programmer debugging
Notes:
Do not inset or draw out the debugger with power; do after power disconnection.
Debugger operation:
The debugger is connected to the telecommunication interface of controller to display
XXXX-XXXXXXX characters; enter the menu of parameter of automatic door by
pressing SET and adjust UP or DOWN; open the door by TEST.
If no pressing after 30s, back to the menu displaying XXXX-XXXXXXX characters;
When the S/N is being selected by SET, press UP/DOWN to adjust the number scope
and SET to save.
Operation Procedure
Activated by the signals from external control device, unlock
→
open
→
damping
action&stop
→
hold-open
→
close
→
damping action&stop
→
lock and seal.
Debugging
S/N
Value scope
Initial value
Function description
1
10-100
65
Opening speed `
2
10-100
55
Closing speed
3
1-10
2
Damping opening speed
4
1-10
2
Damping closing speed
5
1-60
20
Damping opening distance
6
1-60
20
Damping closing distance
