REVISIONS AND ORDERING INFORMATION
STM32-P107
– fully assembled and tested
You can purchase directly from our online shop or from any of our distributors. Note that usually it is
faster and cheaper to purchase Olimex products from our distributors. List of confirmed Olimex LTD
distributors and resellers:
https://www.olimex.com/Distributors
.
Please visit
https://www.olimex.com/
for more info.
User's manual revision history:
REV. I
- created December 2009
REV. A
- edited by TU December 2010
REV. B
- demo software added and mechanical dimensions detail
REV. C
- rev. A schematic and added more programmers in BOARD USE
REQUIREMENTS.
REV. D
- edited June 2011 – changed schematic
REV. E
- changed schematics to rev. B, added board revision history
REV. F
- added BOOT0_E, RST_E description, changed dimensions, updated
revision B pictures, updated disclaimer
REV.G
- updated the information to fit board revision C, updated schematics,
improved document layout, added product support information, updated
links
REV.H
- improved information about bootloader
REV.I
- changed the schematic on page 8
REV.J
- added picture of the protoarea pads with their respective labels
REV.K
- added new information about DFU mode, hardware revision D changelog
REV.L
- February 2018 - added table that details the protoarea pinout
Board revision history:
rev. A
========
1. ST2052BD is exchanged with LM3526-L.
2. SD/MMC signals are changed as follows:
SPI1_MOSI ->
SPI3_MOSI
SPI1_SCK
->
SPI3_SCK
SPI1_MISO ->
SPI3_MISO
and SPI1_NSS renamed to CS_MMC
3. Changed the polarity to + of C36
rev. B
========
1. Ethernet PHY is changed from STE101P to MICREL's one – KS8721BLMM
2. All 10uF/6.3V/TANT are changed to 0805 and a lot of element names are changed.
3. PWR_SEL jumpers are replaced by diodes.
4. USART3 is connected to UEXT while USART2 is connected to RS232 and bootloader functionality is
enabled! Two additional jumpers are added!!!
5. Added UEXT_PWR_E jumper!
Page 21 of 23
