Olimpia splendid Arcadia PANORAMICA, Instructions For Installation, Use And Maintenance Manual

3

INSTALLATION

(SECTION DEDICATED TO THE INSTALLER)

RULES AND REGULATIONS

· Read this manual carefully as it contains important indications and instructions concerning the installation, use, maintenance and

safety of the product.

· This appliance must only be installed and used in a room deemed suitable by the specific authorities and in compliance with the

relevant rules and regulations.

· The technological systems and the installation of the appliance must be done by professional qualified personnel authorised to

release the certificate of conformity and compliance with the regulation in force.

· All the laws, rules and regulations in force concerning civil and industrial buildings must be respected, always using PPE and other

means foreseen by law.

· All laws, rules and regulations concerning the systems, chimney flues, electricity, water, ventilation and aspiration must be respected.
· The manufacturer declines all responsibility arising from incorrect installation, tampering, incorrect use of the

appliance, improper use, poor maintenance, and failure to respect regulations in force.

PRELIMINARY OPERATIONS

· Carefully remove the packing.
· The packing material must be recycled by disposing in the special containers or in the local municipal waste disposal site.
· Before installation, make sure that the appliance is intact, in case of doubt, do not use it and contact the vendor.

POSITIONING THE APPLIANCE

· The place where the appliance is installed must have:

- A floor suitable for supporting a weight greater than that of the appliance. If the existing building is not suitable, appropriate

measures must be taken (e.g. a load distribution plate);

 - Flooring suitable for heat dispersion which protects the building against fire risks;
 - The installation of the appliance must guarantee easy access for its cleaning, the cleaning of the exhaust gas ducts and the

chimney flue;

- The appliance must be positioned on a horizontal surface;
- A minimum distance from adjacent inflammable material;
- A permanently ventilated room in accordance with the regulations in force.

PROTECTION OF THE FLOOR

· The appliance must rest on a refractory surface. In the case of inflammable flooring (wood, carpet, etc.) prearrange a refractory base

(steel sheet, tiles or similar) with the following size:
- Frontal protrusion 

≥

≥≥

≥≥

 500 mm;

- Side protrusion 

≥

≥≥

≥≥

 300 mm;

- Rear protrusion 

≥

≥≥

≥≥

 100 mm.

1

1.1

1.2

1.3

1.4

1