48
3.4
External unit assembly
After checking the suitability of the base (if prepared by a
third party) mount the external unit adopting the following
precedure:
a) Position the appliance on the base using the elastic
vibration-damping blocks if necessary.
b) Tighten the anchor bolts slightly.
c) Check that the appliance is horizontal in both directions
(fig. 12). If necessary, shim the supports until the
appliance is level.
d) Tighten the anchor bolts.
e) Open the attachment access door (fig. 13).
f)
Connect up the cooling lines according to paragraph 3.5.
g) Connect up the electrical lines as specified in paragraph
3.7.
h) Reassemble the access door to the connections.
Fig. 12
Fig. 13
