6
Iron does not heat
ProBLeM
ThinGs To checK
soLUTion
Scorch guards do
not come out
Iron does not
steam
Iron leaks
Iron is emitting a brown
or white substance
Is fabric selector set to off?
Is iron plugged in correctly?
Is Auto shut-off system activated?
Is iTouch™ switch set to off?
Is iron plugged in correctly?
Is handle activated?
Is iron hot enough?
Is steam selector set to off?
Is steam valve clogged?
Is iTouch™ off, and iron is horizontal?
Is iron is hot enough?
Has steam burst button been overused?
Is water hardness too high?
Turn the fabric selector knob to a fabric setting.
Check to make sure the plug is fully plugged into the socket.
Touch the handle.
Set the switch on the back of the iron to the ON position.
Check to make sure the plug is fully plugged into the socket.
Move your hand away from the iron, and the iTouch™ Technology will raise the sole-plate.
The fabric selector must be set to the wool, cotton or linen settings to produce
continuous steam.
Steam selector must be turned to a setting.
Move the steam selector from off ( ) to the max ( ) settings a few times to
unclog.
When the iTouch™ switch is set to OFF, always store the iron in the vertical position. We
recommend turning on the iTouch™ Technology to store the iron.
Make sure the fabric selector knob is set to the cotton or linen range to ensure proper
steam production.
Allow 3 seconds between uses of the steam burst function.
Switch to either spring water or half tap/half distilled water mixture. See the “water
tank” page for more information.
Trouble shooting guide
Maintenance/cleaning
The soleplate should be cleaned if starch or other residue builds up. When the iron is cool, wipe the soleplate with a soft, damp
cloth. Do not use abrasive cleaners or scouring pads as this will damage the iron’s soleplate.
Mineral deposits from tap water can occur in the soleplate vents. To clean, fill the water tank and heat the iron to the linen fabric
setting. Once the iron is fully heated, unplug the iron and hold over a sink. Press the steam button repeatedly until water begins to
drip out of the soleplate. Be careful, as this creates large amounts of steam.
To ensure optimal steam production, the steam valve should be regularly cleared of accumulated debris and minerals. This is done
by moving the steam selector back and forth from the off ( ) to the max ( ) steam settings several times.
© 2009 Oliso, Inc. All rights reserved. iTouch, Flip Funnel, and Smart Iron are trademarks of Oliso Inc. Oliso is a registered trademark of Oliso Inc. U.S. Patent No. #6,453,587 B1,
#6,925,738 B2. Patent Pending #40000031 <04/09>E Printed in China.
Summary of Contents for Smartiron
Page 1: ...User Manual ...
