4430 Planer
OLIVERMACHINERY.NET
47
|
Page
Troubleshooting
Problem
Possible Cause
Possible Solution
Machine does not start.
Stop button is not
reset.
Turn the rim of the STOP button clockwise to
reset. The stop button will pop up.
Machine is not
connected to a power
source.
1.
Make sure the machine is plugged in, or
the power disconnect is at the ON position.
2.
Check the electrical panel for a tripped
circuit breaker or a blown fuse.
3.
Ensure all electrical connections have good
contacts.
Low voltage / current.
Have an electrician to check/repair the circuit.
Faulty switch/motor/
capacitor.
Contact customer service for further
assistance.
Machine trips the
thermal protection or
the circuit breaker, or
blow fuses.
Machine is undersized
for the operation.
Reduce the depth of cut and/or feed rate.
Workpiece moisture
level is too high.
Only plane wood with a moisture level below
20%.
Machine is jammed.
Inspect the cutterhead and make sure it is not
obstructed by woodchips. Check dust port and
headstock and clear blockages.
Too much load on a
circuit.
Make sure the power circuit is sized for this
machine. If the same circuit is shared, ensure
the circuit is sized to supply power for all items
in the circuit.
Motor/capacitor issue.
Contact customer service for further
assistance.
Machine stalls during
operation.
Machine is undersized
for the operation.
Reduce the depth of cut. Lower feed rate.
Dull cutters
Rotate/replace cutter inserts.
Belt slipping
Clean belt and the pulleys. Adjust belt tension.
Motor/capacitor issue.
Contact customer service for further
assistance.
Machine stopped during
an operation.
Thermal overload
protection triggered.
Hit the STOP button to reset overload
protection. Wait for the machine to cool down.
Reduce the depth of cut and feed rate.
Drive chain jumps during
operation.
Loose chain.
Adjust chain tensioner.
Misaligned sprockets.
Align sprockets.
Worn sprockets.
Replace sprockets and chains.
Digital readout not
functional.
Dead battery.
Replace battery.
Summary of Contents for 4430.201 M-4430
