14
Adjustment of Pressure Bar
The pressure bar should be set even with the
lowest point of knife. Make sure the knives are
set properly see the “Setting / Changing Knives”
section on page 11 prior to making any
adjustments.
1.
Disconnect machine from power source.
2. Place a hard wood gauge under a knife in
cutterhead. Raise table until wood gauge
contacts the knife in its lowest position.
3. Place wood block (A, Figure 16) under the
left side of pressure bar (B, Figure 16). The
top of wood gauge should just contact the
pressure bar. If it doesn’t, loosen jam nut
(C, Figure 17) and turn the adjusting screw
(D, Figure 17) to raise, or lower the pressure
bar until it contacts wood gauge. Repeat for
opposite side of the pressure bar.
Adjustment of Out-feed Roller
The out-feed roller should be set 0.02” below the
lowest point of knife. Make sure the knives are
set properly see the “Setting / Changing Knives”
section on page 11 prior to making any
adjustments.
1.
Disconnect machine from power source.
2. Place a hard wood gauge (A, Figure 13)
under a knife in the cutterhead. Place a
0.02” feeler gauge (B, Figure 13) on top of
wood block and raise table until the gauge
contacts the knife in its lowest position.
3. Remove feeler gauge and place wood block
(E, Figure 18) under the left side of out-feed
roller (F, Figure 18). The top of wood gauge
should just contact the out-feed roller. If it
doesn’t, loosen jam nut (G, Figure 17) and
turn the adjusting screw (H, Figure 17) to
raise, or lower the out-feed roller until it
contacts wood gauge.
Summary of Contents for 4455
Page 19: ......
