14
Setting the Size
The amount to be planed from the bottom of the workpiece is set by adjusting the height
of the infeed table in relation to the bottom cutterhead This is done by using the infeed
table adjustment hand wheel, located under the infeed table. The gauge for reading the
planning amount is located to the right of the pointer gauge, on the infeed table.
Once the lower planning value is set, use the elevation buttons and micrometric
adjustment hand wheel to move the upper portion of the machine, so that the upper
planning amount is set. The total amount to be planed will be read on the thickness
gauge. Make a trial cut and measure the planed workpiece to confirm that the thickness
gauge is correctly calibrated.
NOTE:
It it recommended that a cutting ration of 1.5:1 be used for upper and lower
cutting. i.e., to plane 10mm from the workpiece, set the lower planning value to
4mm and the upper planning value to 6mm.
The maximum lower planning value is 5mm, and the maximum upper planning
value is 8mm.
Summary of Contents for 5235
