16
Adjusting the Feed Chain
The feed chain tension is adjusted by the two chain tension screws located at either
side of the infeed end of the table. If the feed chain is too loose, it will cause binding and
excess noise during workpiece feed. Tighten the screws to increase tightness.
To adjust the pressure, loosen the fixing lever on the eccentric board, and move the
eccentric board up or down to obtain the correct pressure. Retighten the fixing lever
after adjustment, in general, greater feed chain pressured is required for harder woods.
Check the relative hardness of the wood stock before planning.
Summary of Contents for 5235
