732-N Front Load Slicer
0732S20007
6-10
Replacing the Gas Spring (Continued)
WARNING
THE GAS SPRING IS IN A COMPRESSED STATE, USE
CARE WHEN REMOVING IT FROM THE MACHINE.
To remove the gas spring, remove the push-on clip at the top of the gas spring by prying
it off with a screw driver.
NOTE
THE CLIP IS NOT REUSUABLE; A NEW ONE WILL BE REQUIRED.
After the clip is removed, the gas spring can then be pried off with a screwdriver, use
care noting the above warning. See the next illustration for additional information. After
the spring is off the pin the shoulder screw securing the lower end of the spring can be
removed freeing the spring.
Install a gas spring by first attaching the lower end of the spring to the pusher arm with
the shoulder screw.
CAUTION
USE A LOCKING FLUID, SUCH AS LOC-TITE ®, TO PREVENT THE
SCREW FROM LOOSENING BECAUSE OF VIBRATION.
Continued
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
