7
ENGLISHENGLISHENGLISHENGLISHENGLISH
BASIC COPYING
BASIC COPYING
BASIC COPYING
BASIC COPYING
BASIC COPYING
ST
ST
ST
ST
STAR
AR
AR
AR
ARTTTTT-UP
-UP
-UP
-UP
-UP
!
Make sure that the power plug is correctly inserted in the mains socket.
To switch the machine on or off, use the POWER SWITCH (B37).
After 30 seconds the machine is operational.
The following standard copy settings are activated (unless they have been changed).
Standard copying:
Copy ratio:
Direct (100%)
Paper size:
Automatic selection
Exposure :
Automatic control
Number of copies:
1
If the photocopier is set up to work with the optional control card (
☞
«Control card / Printer unit», p. 41) the
CONTROL CARD indicator (B8) starts to blink and you must insert a control card in the slot (inside cover, sect.
G) or enter an enabled ID name.
PLA
PLA
PLA
PLA
PLACEMENT OF
CEMENT OF
CEMENT OF
CEMENT OF
CEMENT OF THE ORIGINAL
THE ORIGINAL
THE ORIGINAL
THE ORIGINAL
THE ORIGINAL
Original placement varies according to whether there is an automatic feeder (ADF or RDF) installed.
BASIC COPYING
BASIC COPYING
BASIC COPYING
BASIC COPYING
BASIC COPYING
If the standard copy settings of the photocopier (1:1 copying, automatic paper size selection, automatic exposure
control, one copy) meet your requirements, you may now start copying. Otherwise, before proceeding,
☞
«Copy
Settings», p. 8.
Paper Feeding
The paper is automatically fed in from the cassettes or, if special paper is used, from the stack bypass (
☞
«Using
the Stack Bypass», p. 11).
If there is an automatic feeder (ADF
or RDF) installed:
Adjust the paper guide in accordance
with the size of the originals.
Place the originals in the tray with the
side to be copied facing upwards.
!
A5 documents cannot be pla-
ced horizontally in the automa-
tic feeder
The capacity of the feeder document
tray is as follows:
Size
ADF
RDF
A3
15
25
A4, A5
30
50
Lift the cover of the glass platen and
place the original with the side to be
copied face down. Align the centre of
the original with the arrow-shaped
mark.
Gently lower the glass platen cover.
If there is no automatic feeder: