10
RAM RESET PROCEDURE
If after powering the cash register off and on (both by pressing the On/Off key and by
disconnecting the 220V power supply cord, as described in step 1 on page 2), and
after performing the operation reset procedure, the cash register has still not returned
to a normal operating condition, proceed as follows.
1.
Power off the cash register by pressing the
key on the operator panel.
2.
Disconnect the power cord.
NOTE:
if the electrical socket is within easy reach, it is preferable to disconnect the
power cord from the electrical socket rather than from the cash register.
3.
Wait for approximately 20 seconds, then reconnect the power cord.
4.
Now, without disconnecting the cash register from the power supply, extract the
customer display from its slot until only the last part is still inserted, as shown in
the illustration below.
(
This operation makes it easier to raise the upper cover to gain access to the
controller board housed inside the cash register).
