FAX Operation (Advanced)
4-14
Remote Switch Function
You can start fax reception by operation from the connected telephone set. This function is convenient for using
this machine and a telephone set (commercially available product) in combination installed at places distant
from each other.
To start fax reception by operation from the connected telephone set, use the following operation.
NOTE:
In order to use remote switch, it is necessary to connect the tone signal-sending telephone set
(commercially available product) to the machine. However, even if it is a tone signal-sending telephone set,
this function may not be used satisfactorily depending on the type of telephone set. For details, contact our
agent or the store where you purchased this machine.
How to Register Remote Switch Dial
Remote switch dial is set to 55 at the factory, but you can change the dial number.
1
Press the
System Menu/Counter
key.
2
Press the
U
or
V
key to select [FAX].
3
Press the
OK
key.
4
Press the
U
or
V
key to select [Reception].
5
Press the
OK
key.
6
Press the
U
or
V
key to select [Remote SW Dial].
7
Press the
OK
key.
8
Use the numeric keys to enter the number to be
newly registered (00 to 99).
9
Press the
OK
key.
Summary of Contents for d-COLORMF2604
