8-9
Fax Settings > Default fax settings
2 in 1 Print
When you receive a multi-page Statement or A5 size original, this function prints 2 pages of the
original at a time on one Letter or A4 size sheet of paper.
Value
: Off, On
Batch Print
When a multi-page fax is received, the pages are printed in a batch after all pages are received.
If [Off] is set, each page is printed as it is received.
Value
: Off, On
Rings(Normal)
If the reception method is fax automatic reception, the number of rings until the machine
answers a call can be changed as needed.
Value
: 1 - 15
Rings (Answering Machine)
If the reception method is FAX/Answering Machine Auto Switch Reception, the number of rings
until the machine answers a call can be changed as needed.
Value
: 1 - 15
Rings(FAX/TEL)
If the reception method is FAX/TEL Auto Switch Reception, the number of rings until the
machine answers a call can be changed as needed.
Value
: 0 - 15
For Rings (FAX/TEL), this change is possible with some countries.
Reception Mode
Select the reception mode.
Value:
Auto (Normal), Auto (FAX/TEL), Auto (Answering Machine), Manual, Auto (DRD)
If Auto (DRD) is selected, select the DRD Pattern.
Value
: Pattern 1 (Normal Ring), Pattern 2 (Double Ring), Pattern 3 (Short-Short-Long),
Pattern 4 (Short-Long-Short)
DRD reception mode is available for some countries.
FAX Automatic Reception (page 4-2)
Manual Reception (page 4-4)
FAX/TEL Auto Switch Reception (page 5-28)
FAX/Answering Machine Auto Switch Reception (page 5-30)
DRD Reception (Available for some countries.) (page 5-32)
Remote SW Dial
To start fax reception by operation from the connected telephone set, use the following operation.
Value
: 00 - 99
Remote Switch Function (page 5-36)
Encrypted Reception
Turns on reception by encrypted communication.
Value
: Off, On
If turned on, select the encryption key.
ECM RX
Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International Telecommunication Union)
that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and
other conditions.
Value
: On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly longer than
when [
Off
] is selected.
RX Start Speed
Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In that case,
set a lower RX Start Speed.
Value
: 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Item
Description
Summary of Contents for d-COLORMF3023
Page 1: ...Code 597300en d COLORMF3024 FAX OPERATION GUIDE...
Page 190: ......
