1-3-89
Setting: Busy tone
When a fax signal is sent, sets whether the line is disconnected immediately after a busy tone is
detected, or the busy tone is not detected and the line remains connected until T0 time-out time.
Fax transmission may fail due to incorrect busy tone detection. When set to 2, this problem may
be prevented. However, the line is not disconnected within the T0 time-out time even if the desti-
nation line is busy.
1. Select the setting.
Display
Description
On
Detects busy tone.
Off
Does not detect busy tone.
* : Initial setting: On
2. Press the start key. The setting is set.
Setting: PBX Setting
Selects the mode to connect an outside call when connected to a PBX.
According to the type of the PBX connected, select the mode to connect an outside call.
1. Select the setting.
Display
Description
Flash
Flashing mode
Loop
Code number mode
* : Initial setting: Loop
2. Press the start key. The setting is set.
Setting: DC loop
Sets if the loop current detection is performed before dialing.
1. Select the setting.
Display
Description
On
Performs loop current detection before dialing.
Off
Does not perform loop current detection before dialing.
* : Initial setting: On
2. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Service Manual
Y116
540-5
Summary of Contents for d-Copia 4003MF
