3
ENGLISH
Unpac
Unpac
Unpac
Unpac
Unpacking and Setting Up the Cash Reg
king and Setting Up the Cash Reg
king and Setting Up the Cash Reg
king and Setting Up the Cash Reg
king and Setting Up the Cash Register
ister
ister
ister
ister
NOTE: Please read this section carefully before attempting to program
the cash register or perform sales transactions.
As soon as you receive the cash register, open its shipping carton and
carefully withdraw each component. Make sure that the cash register
and all of its accessories, listed in the section entitled Standard
Accessories, are present in order to setup the cash register by following
these guidelines:
1. Place the cash register on a level, stable, vibration-free and dust-
free surface. Make sure it is near a grounded power outlet.
2. Remove the adhesive tape from the compartment cover.
3. Insert the batteries as explained in the section entitled Inserting/
Replacing Batteries.
4. Install the inked ribbon cartridge as explained in the section entitled
Installing the Ribbon Cartridge.
5. Plug the cash register into a grounded power outlet.
6. Load the paper tape as explained in the section entitled Loading
Single-Ply and Dual-Ply Paper.
7. Set the desired program options as explained in the section Cash
Register Programming.
8. Once the desired program options have been set, turn the control
key to the REG 1 or REG 2 position and you are ready to perform
sales transactions. In the REG 2 position the cash register will not
print the programmed receipt header.
Maintaining the Cash Reg
Maintaining the Cash Reg
Maintaining the Cash Reg
Maintaining the Cash Reg
Maintaining the Cash Register
ister
ister
ister
ister
Provided below is information on how to maintain your cash register.
NOTE: Before cleaning the cash register, make sure it is powered off
and/or unplugged from the wall outlet. Before unplugging the
cash register from the wall outlet, make sure that four charged
AA standard backup batteries are installed in the battery
compartment. All data stored in memory will be cancelled if
you unplug the cash register from the electrical wall outlet
without back-up battery supply.
1. Keep all liquids away from the cash register so as to avoid spills
which could damage the electronic components.
2. To clean the cash register firstly turn it off and/or unplug it from the
wall outlet (be sure the back-up batteries are installed), then use
just a damp cloth. Do not use corrosive substances such as solvents,
alcohol, petrol, or abrasive components.
3. If the cash register is stored in extreme hot or cold temperatures
(below 32 degrees or above 104 degrees Fahrenheit), allow the
temperature inside the cash register to reach room temperature
before turning it on.
4. DO NOT attempt to pull the paper tape when the cash register is
printing or when you are loading paper. Always use the [Feed] key
to feed paper. Pulling the paper tape could damage the print
mechanism.
