GB-11
ENGLISH
LOADING THE JOURNAL ROLL
Proceed as follows to load a journal roll into the cash register:
1. Make sure that the cash register is plugged into a grounded power outlet and that the Control Key is in either
one of the two REG positions.
2. Unlock and remove the printer compartment cover as explained in Loading the Customer Receipt Roll.
3. If you are replacing the journal roll, lift the 2-piece plastic journal winder spindle from its two supports on the
machine and, if necessary, move the plastic paper release lever
(A)
located to the right-hand side of the journal
paper insertion slot forward to release the paper which may still be present in the print mechanism. Then slide
the journal paper off the plastic winder.
4. With a pair of scissors, cut the end of the new paper tape to create a straight, even edge so that the paper can
be properly fed through the print mechanism.
5. Set the journal roll in its predefined slot at the rear right-hand side of the printer compartment so that the paper
feeds out from the bottom of the roll. Then insert the end of the paper into the related paper feed slot as shown
in the following figure.
6. Press the
[J Feed]
key and manually feed the paper into the slot until its catches and advances approximately
six to ten inches above the print mechanism.
NOTE:
If the paper does not feed properly, make sure that the paper roll is properly aligned in the slot and that the
end of the paper roll is cut straight. If you need to remove the paper tape so that you can attempt to reload
it again, move the plastic release lever
(A)
on the right-hand side of the print assy forward, and clear the
paper from the slot.
7. Holding the main body of the 2-piece plastic journal winder with the two wheels to the right-hand side, slide the
end of the paper tape through one of the slots on the plastic journal winder spindle
(1)
and manually roll the
winder toward the rear of the cash register
(2)
to take up the slack in the paper tape.
2
1
A
Summary of Contents for ECR 3550 T euro
Page 46: ...Code 506574 V...
