2.3.3
Installation of the Customer display (field option)
To assemble the Customer display proceed as follows:
•
Fasten the support to the base tightening screws
A
.
•
Pass cable
B
through the hole of the support and connect it to the display
C
.
•
Fasten the display to the support using screw
D
and the clip
E
.
•
Connect the display to the COM port
F
.
•
Fasten the base to the supports
G
fastened previously to the base module.
Figure 2-4
Figure 2-5
A
A
B
C
A
G
D
F
Figure 2-6
After installing the device, check the setting of the COM port used. Refer to the description of the jumpers in
the previous chapter for correct powering of the module.
Correct functioning of the device can be tested using the “Test Program” on the driver installation CD.
2-6
XZAC3272
Summary of Contents for Explor 200M
