42
5. To confirm the selection, press the key:
The display shows:
TYPE TIME
HH:MM
From here on, proceed as described in “
Transmitting a
document in polling mode
”.
P
REPARING
THE
DOCUMENT
FOR
TRANSMISSION
(
POLLING
TRANSMISSION
)
1. Place the original document in the ADF.
The display shows on the top line:
DOCUMENT READY
and on the bottom line, the default contrast value: NORMAL.
The initial resolution value (even if it is not shown on the
display) is: “
” (standard).
If necessary, change the contrast and resolution values (see
“
Setting contrast and resolution
”, chapter “
Basic
transmission and reception operations
”).
2. Press the key:
until the display shows:
POLLING TX
3. Twice press the key:
The second line of the display shows: “POLLING TX SET”.
Note
You can delete the polling operation that has been set up.
1. Do so by removing the document from the ADF or by pressing the
key.