8
Changing the position ...
Procedure
DISPLAY
1
Press the FUNCTION
key until the display
shows --->
FAX SET-UP
2
Press the START key.
DATE AND TIME
3
Press the FUNCTION
key.
VARIOUS SETTINGS
4
Press the START key
until the display shows
--->
HEADER INSIDE
5
Press the </> key to
select the alternative
parameter.
HEADER OUTSIDE
6
Press the START key
to confirm the setting.
RETRANS. DOC.: OFF
7
Press the STOP key to
restore the fax machine
to its initial waiting
mode.
AUTOMATIC RX
21-05-99 10:40
The fax machine may operate as an independent fax
machine or telephone or as a photocopier; see
“Configuring the fax to the telephone line” and sub-
sequent paragraphs for a description of the operations
that may be performed on it.
For the multi-use model ...
If you want to use the fax machine as a printer or scan-
ner, you must connect it to a PC and install the relevant
software. Continue to follow the instructions given in this
paragraph.
TO CONNECT IT TO A PC ...
1. Make sure that the fax machine and the PC are both
turned off and/or disconnected from the electrical power
supply.
2. Plug the connector at one end of the interface cable
to the parallel port on the rear of the fax machine.
3. Plug the connector at the other end of the cable to the
parallel port of the PC.
4. Reconnect and/or turn on both the fax machine and
the PC.
TO LOAD THE SOFTWARE ...
The fax machine comes with the software required to
perform the printing function.
Minimum Requirements of the PC:
•
For Windows 95 and Windows 98 first edition: Pentium
166 MHz, 32 MB of RAM.
•
For Windows 98 second edition, Windows NT4, Win-
dows ME and Windows 2000: Pentium 166 MHz,
64 MB of RAM.
All configurations require at least a CD drive, a VGA
monitor (24-bit board for colour video) and an IEEE 1284
Nibble Mode parallel interface connection.
TO INSTALL THE "LINKFAX" SOFTWARE ...
The installation CD contains a fax/PC interconnection
program, a printer driver and the on-line documentation
files containing other information about the functions
performed by the fax machine in the PC environment.
The program, driver and documentation files copied to
the hard disk of the PC during installation will take up
about 20 MB of space on the hard disk.
WINDOWS 95/98/ME ENVIRONMENT ...
"Plug & Play" Installation ...
This kind of installation may only be performed after
connecting the fax machine to the PC and the power
supply (fax machine powered on).
1. Power on the PC and, while Windows 95(*)/98 is
being started, insert the installation CD supplied
with the machine in the CD ROM drive.
2. Once Windows 95/98 has been started, a dialog box
appears indicating that a new hardware compo-
nent has been detected and prompting you to select
the related driver that is to be installed.
The driver on the disk provided by the hardware
manufacturers is selected by default.
Confirm (OK).
3. The dialog box for installation from the CD ap-
pears on the screen.
Confirm (OK).
-1--1-10.p65
02/04/01, 9.17
8
