T
RANSMITTING AND RECEIVING
23
5.
Replace the handset. The fax machine begins
receiving the message and the display shows in-
formation regarding the incoming message, in-
cluding the sender’s fax number or (if pro-
grammed) his name.
6.
On completion, the message “RX COMPLETED”
is shown on the display for a few seconds, and
then the fax machine returns to the initial waiting
mode.
MANUAL 100%
09-10-00 14:09
If the caller called just to speak, replace the receiver
at the end of the conversation.
If your telephone installation has several sockets
and the connected telephone is not near the fax
machine, you can enable the fax machine for re-
mote reception (REMOTE) provided that the tele-
phone works with tone dialling (multi-frequency):
•
Connect to the line by lifting the handset.
•
Press the * key on the telephone, followed by
the remote control code. Remember that the
code must be the one previously programmed
(see “Changing the remote control code” in
“For more sophisticated use”).
Automatic reception
The fax machine receives documents automatically
without any intervention.
The fax machine is already programmed to receive
documents in automatic mode. However, if it is pro-
grammed differently, press the
key until the
display shows “ RX ON FAX ”.
Automatic reception with call type rec-
ognition
You have programmed the fax machine by pressing
the
key to receive in this mode (the display
must show “ FAX/PHONE”).
The behaviour of the fax machine in this reception
mode will depend on the caller. This procedure is
illustrated in the following diagram:
