Operating Instructions
This appliance is for salon or household use, and may be
plugged into your AC electrical outlet (100-240VAC 50-60Hz).
If you are traveling, use the appropriate adapter to plug in your
electrical outlet. Your curling iron will then automatically adjust
itself to the adequate voltage and function.
IMPORTANT
Keep heated surfaces away from contact with all skin areas
and eyes. Do not touch the barrel or clip with fingertips. For
shorter hair, place a thin heat resistant plastic comb between
scalp and curling iron to avoid touching scalp. Test a small
section of hair before styling the whole head.
1. Place the curling iron on a smooth and flat surface, ideally on
your heat resistant mat, and then plug into the outlet.
2. Press the power button to turn curling iron on.
3. Allow 1 minute (or less) for curling iron to reach the maximum
temperature.
4. Work with hair sections that are no more than 1” wide and
1⁄4” thick.
5. Place hair in between the clip and the barrel, at the top part of
the strand of hair you are working on.
6. Twist hair around barrel & move slowly from top of hair to
ends, to ensure even curling.
7. Release pressure from clip and allow the hair strand to slip out.
CAUTION: Hair will be hot. Let the hair strand cool
before touching.
8. Repeat until desired result is achieved.
9. Press and hold the power button for 3 seconds to turn the
curling iron off.
10. Unplug the curling iron.
ERROR Message:
All lights blinking
simultaneously
If the temperatures lights are all blinking at the same time,
it means that the curling iron switched to standby mode for
safety protection. Please follow the following steps:
1. Turn curling iron OFF and unplug it from outlet.
2. Wait about 2 minutes leaving the curling iron unplugged.
Then plug in your curling iron into outlet and turn it ON.
3. If the temperature lights have stopped blinking, you can resume
using your curling iron.
4. If the temperature lights are still blinking, discontinue use of the
curling iron and contact Olivia Garden or your local authorized
distributor.
5. Refer to the warranty section of this book for more details.
Note: This “ERROR” message can be a sign that the curling iron
is not functioning properly or that it is not reaching the
temperature as expected, and that the iron switched to a
standby mode for safety protection.
Care & Maintenance
To ensure optimum performance of your curling iron, the barrel
and clip should be cleaned regularly.
• Before cleaning, ensure that the curling iron is switched OFF,
has cooled down and is unplugged from the power supply.
• Use a soft cloth slightly moistened with water to clean the
barrel, clip and the external surface of the handle. Do not
apply water or cleaning agents directly onto the curling iron.
• For USA in-salon sanitizing, please follow your State board’s
rules and regulations.
EN
