Page | 32
2.5 Instructions for mounting product covering
The heater is supplied in two separate packs, one containing the product and
the other containing the majolica tiles.
For mounting the outer covering, simple instructions are provided:
1. Use a crosshead screwdriver.
2. Lift the right side panel, insert the top front majolica tile and replace the panel
in the original position. See figure 2.7.
Figure 2.7: Pellet heater
i
3. For models where the bottom front majolica tile is not already mounted,
open the door, remove the rear panel releasing the locking screws and
insert the majolica tile in the hatch opening, as in figure 2.8. Replace the
panel and close the door.
Top Front Majolica
Tile
(AIR 400x131x15)
Top Front Majolica
Tile
(IDRO 400x254x15)
