30
OIl PRIMARY cONTROl -TROubleshOOTINg
NOTICE
FINAL CHECK OUT
ENSURE THAT ALL SAFETY DEVICES AND ELECTRI-
CAL COMPONENTS HAVE BEEN SET FOR NORMAL
OPERATION. ENSURE THAT ALL ELECTRICAL CON-
NECTIONS ARE TIGHT AND THAT THE WIRING IS
SECURE.
NOTICE
IMPORTANT:
Please ensure that the homeowner is informed and under-
stands:
Where the circuit breaker or fuse is located in the
1.
main electrical panel.
Where the furnace switch is located, and the switch
2.
"on" and "off" positions if not obvious.
Where the oil shut-off valve from the oil storage tank
3.
is located.
How to operate the thermostat, and other related ac-
4.
cessories.
How to operate the manual reset button on the
5.
primary control, and especially when not to push the
reset button.
How and where to visually inspect the venting system
6.
for leaks or other problems.
How to inspect, clean and replace the air filter, and
7.
other homeowner maintenance procedures.
Who to call for emergency service and routine annual
8.
service.
The terms and conditions of the manufacturer's war-
9.
ranty and the contractor's warranty.
Table 12: System and General Trouble Shooting
continued from previous page
Summary of Contents for HTL-100D
