INSTRUCTION MANUAL FOR
WARDROBE FOR DRYING WORK CLOTHES
2
7. Maximum current load of wardrobe is 8 A, transgression of maximum current may cause activation of the wardrobe
protection (draw. 1 pos. 3) and/or protection in local installation. In this situation it is necessary to turn of the trolley
and reset them by pressing button on overheat breaker located on bottom until feel it “click”.
8. The activation of the breaker may be caused by overcurrent made by damage of the wardrobe (look point 4 – 5).
9. For start the drying You need to turn on main switch (draw. 1 pos. 2), the switching position is signaled by the switch
backlight and fan sound.
10. Full cycle of drying is 5 hours and 10 minutes,
a) 5 hours from begin, wardrobe will heating with ventilation,
b) Next 10 minutes will work only ventilation without heating,
c) After that the wardrobe will stop working.
11. Re-inclusion of drying cycle will start after turn off main switch (draw. 1 pos. 2) and repeat point 9 or after temporary
power loss.
12. Before lock the doors check if inside there are no animals and unnecessary items.
13. Knob (draw. 1 pos. 5) is used to adjust the direction of air flow. The regulation is possible in the range of 20-80%. Do
not use strength in max/min position.
14. Maintenance or service of the locker make with disconnected power supply. Do not use strongly caustic detergents
for clearing the locker. Clean locker with dry or damp cloth.
15. Do not put inside very wet clothes (dripping with water).
16. Do not cover ventilation channels located inside and outside of the wardrobe.
17. In case of environmental conditions, the wardrobe might generate noise around 65 dB and warm up to around 40°C.
18. Do not expose the trolley to weather conditions (like rain, sun, etc.). The locker is designed to function in dry and
ventilated room.
19. Max. Load per shelf is 30 kg.
20. Worn out locker should be safely dismantled and disposed of.
Technical data:
1. Fan - 230 V, 50 Hz, 155 W, 705 m³/h.
2. Heater - 230 V, 50 Hz, 1500 W.
3. Connection cable plug with ground 230 V, 16 A (draw. 1 pos. 1).
4. Illuminated main switch 230 V 16 A. (draw. 1 pos. 2).
5. Automatic thermal fuse 230 V 8 A (draw. 1 pos. 3).
6. 2 time relays with time set 5h and 10min. 230 V, 50 Hz, 16 A.
7. Nominal power of wardrobe 1650 W.
8. Wardrobe dimensions (WHD) 1420 x 1970 x 534 mm
