Outdoor Living Today www.outdoorlivingtoday.com sales@outdoorlivingtoday.com
Page 35
D12.
Using
4 - 2” Metal Screws
and
1/4” Nut
Driver
, secure
Metal Roof Panels
down to
lower/front
Batten
row. Do not overtighten!
Locate
Top Siding Piece for Angled Wall
Extender (L/R)
. Position top siding on wall
extender and align as shown above. Attach with
3 - 1 1/2” Finishing Nails
to top wall framing.
There are left/right top siding pieces. Use rough
surface side out.
Center of Battens
Secure lower/front
Batten row, be careful
not to overtighten.
1/4” Nut Driver
and 2” long Metal
Ridge Cap Screw.
Drill through Foam
Enclosures.
Foam Enclosures
D13.
Place
Metal Drip Caps (2 pieces - 60” long)
on top of metal roof at rear. Insert 3 pieces of
Foam Enclosures
underneath metal drip caps and on top of metals roof panels. Enclosures may
need to be snipped down in length to fit. Evenly space from side-to-side allowing caps to overlap
each other. Overhang the cap approximately 1” past each end. When ridge cap is
correctly positioned, secure with
4 - 2” Self Tapping Metal Screws
using 1/4” Nut Driver as per
Step D10
. Screw into to top batten. Do not overtighten.