91” across
49.
Roof Gussets
are positioned on middle
Rafters
. Prior to
attaching
,
make sure walls are properly aligned. Have two helpers
push walls at the top from the outside of shed until inside to inside
measurement between front and rear plates is 91”. Use a level to
square
Gusset
. Attach Gusset with 4 - 2” screws. First
Gusset
will
sit below Rafter Nailing Cleat, second flush with Rafter.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com sales@outdoorlivingtoday.com
Page 28
Parts (Step 49)
Roof Gussets
(3/4” x 3 1/2” x 72”)
x 2
Hardware (Step 49)
S3
- 2” Screws
x 8 total
50.
Attach all
Single
and
Double
Rafter Brackets
where rafters meet
Top Wall Plates
inside of shed.
Attach with
2 - 1 1/4” screws
and
2 -
2” screws
per
Single Bracket
and
6 - 2” screws
per
Double Bracket.
2” Screws
2” Screw
2” Screw
1 1/4” Screw
2” Screws
1 1/4” Screw
Hardware (Step 50)
S2 - 1 1/4” Screws
x 8
total
S3 - 2” Screws
x 20
total
Y30 - Single Rafter Brackets
x 4
total
Y31 - Double Rafter Brackets
x 2
total
48.
Position
Rafter Nailing Cleats
on center Rafter. Top of Rafter
Nailing Cleat should be flush with top of Rafter to support plywood
roof. Position
Rafter Nailing Cleat
to be 4 1/2” from each end of
rafter as shown above. Pre-drill pilot holes in
Rafter Nailing Cleat
and then attach to rafter with
3 - 1 1/4” screws
. Repeat for each
side of the rafter and then on opposite side of the roof.
Parts (Step 48)
Rafter Nailing Cleat
(3/4” x 1 1/2” x 48”)
x 4
Hardware (Step 48)
S2
- 1 1/4” Screws
x 12 total
4 1/4”