78.
Attach
Door Handles.
Handles are
positioned on top section of each door and
mounted with 3/4” Black Screws.
79.
Attach Black Drop Latch as illustrated above
with 2” & 3/4” Black Screws. Note how female part
of Drop Latch is positioned higher than male. Do a
dry run first to position Drop Latch correctly.
Important
- Drill pilot holes with 1/8” drill bit prior to
securing with screws to prevent wood splitting. On
3/4” screw, drill shallow pilot hole only.
77.
Once the Cane Bolt is attached, close doors and mark a hole in the stop to accommodate the
bolt. You can bang the top of the bolt using a hammer and a block of wood to prevent damage.
Once complete, open doors and drill hole where previously marked with 1/2” bit.
2” Black
Screws.
2” Black Screws.
1 - 3/4” Black Screw.
Drill 1/2” Diameter Hole
to accommodate rod of
Cane Bolt.
76.
To secure doors, you will need to install
the
Interior Cane Bolt
to the Vertical Door
Flange. First slide bolt through the upper and
lower brackets. Usually the upper bracket is
positioned between small nubs in the middle
of the bolt. Use 3/4” black screws to secure.
Screw on angle and make sure you attach to
door frame. Pre-drill to prevent wood from
cracking. Attach the holster high enough up
so the handle holds the bolt a few inches
above the door stop.
Upper and
lower brackets.
Holster.
Bolt.
Important - Drill pilot holes
in Door Flange to prevent
wood from splitting.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com sales@outdoorlivingtoday.com
Page 33
