9
Removing the batteries
Follow the steps below to remove the batteries.
Remove the battery compartment cover.
Caution! Danger of short circuit.
•
Remove batteries only with a non-conductive object, e.g. a wooden or plastic spatula.
Remove the batteries.
Replace the battery compartment cover.
External battery source
•
9V battery can be used as an external power source. (9V battery not included in the scope of
delivery).
•
Remove the lower black sticker from the keypad.
•
Place the 9V battery until the metal contacts under the keypad are in contact.
ATTENTION: Only for emergency operation!
Closing the door
•
Close the door of the safe
•
Turn the knob anticlockwise to close the door.
Open door with user code or master code
•
Enter the registered user/master code (4 to 8 digits).
•
Then press the "#" key.
•
You will hear two short buzzer sounds and see the green light turn on.
•
Turn the knob clockwise to open the door.
ATTENTION: The preset user code is "1234" and the preset master code is "123456"!
Opening the door with fingerprint (only for 120FP & 210FP)
•
Press the fingerprint sensor on the control panel with the registered finger.
•
You will hear two short buzzer sounds and see the green light come on.
•
Turn the knob clockwise to open the door.
ATTENTION: In factory setting mode, the door can be opened by any fingerprint!
Opening the door with user code or master code and fingerprint (only for 120FP & 210FP)
•
Press the fingerprint sensor with the registered finger.
•
You will hear 2 short beeps and see the green light flashing.
•
Then enter the user/master code and press the "#" button within 10 seconds.
•
You hear 2 short buzzer tones and the green light lights up.
•
Turn the knob clockwise to open the door.
Setting the user code
•
Open the door and press the reset button once.
•
You will hear 2 short buzzer sounds and see the yellow light flashing.
•
Then enter the new user code (4 to 8 digits) and press "#" to confirm.
•
You will hear 2 buzzer tones, which means that the new user code has been set successfully.
ATTENTION: Please leave the door open until the test of the new code has been successfully completed!
Setting the master code
•
Open the door, press the "0" twice and the reset button once.
•
You will hear 3 short buzzer sounds and see the yellow light flashing.
•
Then enter the new master code (4 to 8 digits) and press "#" to confirm.
•
You will hear 2 buzzer tones, which means that the new master code has been set successfully.
ATTENTION: Please leave the door open until the test of the new code has been successfully completed!
Summary of Contents for GOsafe 120FP Series
