Page
4
of
5
921477000_0
9
_00
5
KEYS UNLOCK AFTER DEVICE ACTIVATION
KEYS UNLOCK AFTER DEVICE ACTIVATION
EXAMPLE OF
ENTRANCE
CODE (
SYSTEM DISARM)
EXAMPLE OF
ENTRANCE
CODE (
SYSTEM DISARM)
Assuming the disarming code is 1234, then to disarm the system,
just
touch
with
y
our
palm
the keys and once the keys
are
illuminated, press "*" then "1234".
Communication error:
If the message "
COMMUNICATION
ERROR
WITH THE
PANEL
" is printed at startup
,
t
his means either the keyboard is not connected to
any network, or it cannot communicate with the
control
panel for some reason.
AUTOMATIC
ADJUSTMENT
OF SENSITIVITY LEVEL
AUTOMATIC
ADJUSTMENT
OF SENSITIVITY LEVEL
DEVICE DEACTIVATION
DEVICE DEACTIVATION
If the keyboard does not detect a human
palm
, it will
power down
after 10
seconds
in order to save power.
I
n this
state
only
the following
functions are
active
:
a) tamper
detection
b)
external contact
detection
c)
detection of the human
palm
near the keys
.
The reasons which cause the
device
to
remain
activated
for more than
10
seconds are described in the
“
Device Activation
” paragraph
.
Energy
sav
ing
:
If the keyboard does not detect the human
palm
over the
keys
for 10 seconds, it turns off the
LCD
backlight of the screen and the keys, even if
it remains on, so it saves energy.
When the device is
deactivated, a
t
ouch to the buttons with the palm of the hand
for 1 second is needed
in order to activate
the device
. As soon as
the device
is
activated
, the LCD screen and the
backlight
of the keys are
lighting
. At this
stage, the keys are locked, and
every
three seconds a message
appears
prompting
the user
to press the
“
*
”
key
so as
to unlock the keypad. Until this
button is pressed, no other button will be activated even if
it is pressed
, and the
buzzer will not sound when the buttons are pressed.
As soon as
we press
“
*
”
,
the keypad is unlocked and the buzzer will now sound when a key is pressed.
When the keypad unlocks, the symbol
(
✔
)
on the screen briefly shows that the
keypad has been unlocked.
IMPORTANT :
The panic key is detected even if the keyboard is locked. So
the user will not have to push the “*” key, instead can directly push the “#”
key for 5 sec. after device activation, in order to send the panic alarm.
Once the batteries are installed, the device detects the surrounding area and
gradually adjusts the sensitivity of the keys. In this case, after installing the
batteries, it is likely that the device will remain
activated
for more than
10
seconds. Also in the event of a significant change, such as being removed from
the wall and held in the user's hand, the auto
matic adjustment
process is
intensified and the device is likely to remain
activated
for more than 10 seconds.
Due to the above, it is suggested during the installation process that the user
should hold in his/her hand the complete device (the keyboard mounted on the
base). Over time the surface of the device will cause any accumulation of dust or
moisture. The process of automatic sensitivity adjustment is quite important
because the device will cope as well as possible with these changes.