Page
10 from
1
4
4. Completing the programming of the
Monday program press the key and
the screen shows with the
indication blinking. By pressing the
2.
Press
7
times the key
and the
screen shows with the indication
blinking
.
The symbol
ΜΟ
(
Monday) means
that you are ready to program the Monday
program and the symbol
WEEK
that you
are in weekly programming mode.
. From now the procedure follows the
steps 8-14 of the daily programming and
you can set the required temperatures on
the required time.
key, the day indicator changes to
TU
(Τuesday) you can repeat the steps for
programming a new program for Tuesday.
The same can be done for the rest of the
days of the week.
3. Press the key and the screen shows
The weekly program in general is based on
the daily programming which is repeated for
every day of the week independently. For
the days of the week that have not been
programmed, the values of the last
programmed day are valid.
For example, if
you program only the days Monday to
Wednesday, then the programming for
Wednesday will be used for the days
Thursday to Sunday.
If you program only
the days Monday, Wednesday and
Thursday then for Tuesday’s program the
program from Monday will be used and for
the days Friday, Saturday and Sunday the
program from Thursday will be used.
5. The completion of the weekly
programming can be done by pressing the
key when the indicator is
blinking. The screen will show the
message briefly and the settings will
be stored in to the devices memory.
1.
Follow the steps
1, 2
,
3
,
and
4
of the daily
programming. Select in the (Mode)
section the setting and press the
key .
6. Activate the device using the key.
The weekly program will start to execute as
WEEKLY PROGRAMING EXAMPLE.
make sure you have programmed the
device clock with the correct time.
(
the thermostat in the OFF state,
prolonged press of the
MENU/ENTER key
and then
22
consecutive presses of the key
lead us to the screen
).
The
number of dashes verifies the correct
connection between the two devices and
also shows the strength of the signal.
The
thermostat must be placed in such a
position that will allow good signal strength
which means that at least 2 dashes must be
shown. If less that 2 dashes are shown the
communication between the two devices is
not good and can lead to communication
errors and bad operation.
After installing the peripheral received
(
BS-
851/R)
,
press the programming key (Figure
1
)
until the indicator
POWER/STATUS (LD1)
starts to blink in a rapid manner. This shows
that the unit is in programming mode.
After
activating the thermostat by removing the
battery separation tape
,
go to the selection
Select mounting areas away from heating
elements, door and window openings and
fireplaces and in general, away for all heat
sources and away from drafts. Mount the
thermostat at a height of about 1.5 meters
and on an interior wall
(
The external wall
have a lower temperature than the internal
wall and can affect the device
).
To completion of the wireless installation
procedure is done by pressing the key
on the thermostat and by a prolonged press
of the programming key on the peripheral
until the
POWER/STATUS(LD1)
indicator
stops to blink and remains ON.
WIRELESS CONNECTION SETTING
MOUNTING
defined. In order for the program to execute
correctly make sure you have programmed
the device clock with the correct time.
ESC
MENU
ENTER
ESC
ESC
ESC
940851000_09_010
