Date 29/6/2021
Document number 921100409_09_002
Page 25 of 73
25 / 73
3.7
Operating via PC (Ethernet)
This chapter contains information on how to monitor and configure the panel remotely via a common web
browser (web interface), on a Local Area Network (Ethernet connection required).
3.7.1
Control panel web interface
To operate the panel via PC (web interface) no special software is required. A common web browser
(Chrome, Firefox, Internet Explorer etc.) can be used. The following instructions have been made using
Mozilla Firefox.
The requirements to operate the panel remotely are the following:
The panel must have an Ethernet adaptor installed, the IP address of the panel must be known, the
computer must be connected to the same local network and the computer’s network settings must be
properly adjusted. All the settings must be done by the building’s network administrator.
Open a web browser and type the panel’s IP address to the URL box (e.g. 10.0.9.105). If the connections
have been done properly the following page will appear.
Please note that you need to do the proper settings via technician menu to set Ethernet adaptor as enabled
and set the IP address of the panel before accessing via web browser.
On the right section are appearing the system’s general information and its status condition.
On the left section with the title LINKS, all available options are appearing for the user with access level 2.
The technician menu is only accessible with level 3 access code.
3.7.2
View current alarms, faults and prealarms
If any of the events above are present to the system, the link to view alarms, faults or prealarms will be
available as first option; else these options will not be displayed.
