Date 29/6/2021
Document number 921100409_09_002
Page 54 of 73
54 / 73
5.3.9
Panel Network
“
PANEL NETWORK
” submenu contains the options listed on the
screen on the right.
Figure5-26.Panel network
First option, “
PANEL ADDRESS
” will open an input window to
configure the control panel’s address within the network of panels.
Each address must be unique. Address number 1 is given to the
master control panel. Addresses 2, 3 and 4 are given to subpanels.
Figure5-27.Panel address
Second option, “
NETWORK SETUP
” is used to enable or disable
panel networking on a control panel. When set to enable, a master
panel enables data transmission via the RS-485 port and a subpanel
reads transmitted data via the same port.
Figure5-28.Network setup
Third option, “
PANELS DETECTION
” starts a scanning sequence
and registers all found subpanels into memory (for master panel
only). This function is crucial for a panel network to operate, after
enabling it.
At the end of the scanning a result of the detected panels will appear
for 2 seconds (second screen on the right).
Figures5-29.Panels detection
