Date
22/4/2021
Document number
921100400_09_005
Page
31 of 71
31 / 71
4.3
Control panel installation
The control panel installation must be done by trained personnel exclusively. Do not touch, add or remove
boards or components, perform connections or do other modifications, while mains power supply is
connected. ESD protection is necessary before touching any of the control panel electronics.
4.3.1
Description of the interior of the panel
To access the control panel
’
s interior first unlock the key-lock on the front with the key (included in
package).
On the door of the panel, is located the CPU control board with the LED indications. The CPU control
board may contain an Ethernet adaptor, a printer adaptor or a MODBUS adaptor at left side (optional).
There is also a Dip-switch selector at the bottom right side of the board, which is used to grand access
level 4 for specific functions. At the bottom left side is also located a Mini-USB port for programming the
control panel via PC.
Figure4-1.CPU control board
On the main body of the metal casing are located the power supply unit (right), the input/output board
(I/O) (left), the loop boards (center), the battery area (bottom), the mounting holes and the cable
openings (see figure 4-2).
4.3.2
Placing the panel on wall
The selected placement area of the panel will have to be clean, dry and free of collisions and vibrations.
The panel must be permanently installed on a steady position. On the following picture the interior and the
mounting holes of the panel are visible. Use all 4 mounting holes for proper installation, using the included
wall mounting accessories of the package.
