Date
22/4/2021
Document number
921100400_09_005
Page
68 of 71
68 / 71
8.2
Functions
Similar to BSR-1001-2-4 the BSR-1000 has the same functionality as far
as the indicators, screen and keypad concerns, as well as the Menu
structure.The only difference is some functions limitation, i.e. the screen
on the right is shown on menus that repeaters cannot access, preventing
wrong actions.
Εικόνα8
-1. Limited acces to repeaters
8.3
Installation
Repeater installation should be carried out in the same way as in other BSR-100x series panels
Follow the instructions on chapter 4 for the repeater installation
8.4
Wiring
The connection of the repeaters is made through the RS-485 protocol. The existing network panel is used
for the connection of the repeaters. The panel network should be implemented by 1 master panel and up
to 3 subpanels and up to 8 repeaters, up to 12 total panels in network. The wiring should be carried out
according to the instructions on chapter 4.5
8.5
Setup repeater network
The repeater has a default address 5. For proper operation it is necessary to setup the network panel.
Prior to any network setup, the address on each repeater and subpanel should be set and after that
address 1 on master panel should be set for network identification.
8.5.1
Setup repeater address
Repeater address is set from the
“TECHNICIAN MENU”
on the
submenu
“SETUP”
by selecting
“PANEL NETWORK”
. Select address
1 for the master panel, 2-3-4 for the subpanels and 5-6-7-8-9-10-11-12
for the repeater panels. Next select
“NETWORK SETUP”
and
“ENABLE”
. This procedure is repeated for every panel connected to
panel network.
Εικόνα
8-2. Panel network address
ATTENTION! Do not set repeater address 5-12 in master panel
–
subpanels or master
–
subpanel address
1-4 to repeater panel.
8.5.2
Panel network detection
In order to complete panel network setup, electrical connection to the mains network as well as connection
between the panels with the RS-485 network should be carried out. Then address 1 is set to master panel
from
“TECHNICIAN MENU”
on submenu
“SETUP”
by selecting
“PANEL NETWORK”
, then select
“NETWORK SETUP”
and
“ENABLE”
and finally select
“PANELS DETECTION”
. During panel detection
master panel will detect every active subpanel and repeater which is available on the network. Eventually,
the master panel will return to main screen. In order to view the detection results select from the master
panel
“INFORMATION”
on the main menu and then select
“NETWORK PANELS”
and
“ACTIVE
ADDRESSES”.
