Page 2 from
3
923193601_09_008
Indications
Charge
6
8
NON MAINTAINED/MAINTAINED OPERATION
JUMPER SELECTION
You can choose the luminaire’s operation. When the
jumper is installed (by default) in the middle and left pins
maintained operation is selected.
When the jumper is installed in the middle and right pins
non-maintained operation is selected
.
Maintained
operation
Non Maintained
operation
INSTALLATION INSTRUCTIONS FOR WALL OR CEILING MOUNTING
1
Unclip the plastic latches with a flat blade screwdriver, unfasten the 2 screws (not all the
way,
step 8 B
) and remove the diffusor. Place simultaneously
2
flat blade screwdrivers to
the
recesses and pull up gently the reflector.
2
Install the base plastic (with the included mounting screws and plugs).
WARNING
!!
To
preserve the
ΙΡ
65
rating, fit the screws with the metallic washers and plastic
rings
which are included.
3
Always use in any case round mains cable
,
with external diameter
of 5
-
10mm
(H05RN-F type 2x1mm²
or
any
other type
,
at least
equal
to it’s mechanical and
electrical properties).
ATTENTION!! The cable must not be deformed in any way (This requirement is
important to ensure the
ΙΡ
65
rating).
Install
the gasket and make a hole in the center by
using a small screwdriver. Pass the round cable through the gasket. Install the second
included gasket in to the unused hole.
4
Place the battery’s connector to the corresponding connector on the P.C.B
.
5
Connect the mains cables to the respective terminal block
Ν
for neutral
,
L
for live wire
.
6
Install the
included tie to fasten securely the power cables.
7
Refit the reflector (mind the holes of the indications).
8
Finally place the diffusor (mind the holes of the indications).
Attention!!
First the plastic
latches (A) must be secured
(click sound)
and then fasten the 2 screws (B)
(tightening torque 1.2 Nm)
.
4
5
N
N
L
L
Mains connection
B
B
A
A
7
1
2
3
