923211004_09_00
4
Page
3 from 4
Figure 1
2
3
Figure 2
1
1.
To instal the device you have to dismantle carefully the
device with a flat screwdriver as shown on figure 1.
2.
Pass the mains cables through the hole
(point 1 on figure 2).
The luminaire must be connected to
a permanent electrical installation
to ensure
the
immobilization of the cable.
3.
Mount the base plastic on the wall by using the included
mounting accessories in points 2 and 3 on figure 2.
4.
Connect the battery`s cable with the appropriate terminal
(figure 3).
5
.
Connect the mains cables to the respective detachable
terminal block
.
Ν
for neutral
,
L for live wire
and
L1 for the
maintained operation
.
The L
1
wire can be connected to an
external switch to control the maintained or non maintained
operation of the luminaire
.
For permanent maintained
operation use two wires to power the luminaire,
Ν
for neutral
and L for live wire, and link the L and
L1.
6
.
Refit with care the removed plastic parts and power on
the luminaire.
N
N
L
L
External
switch
Link
Controled operation
of the illumination source
Permanent
operation of the illumination source
N
N
L
L
L1
L1
NOTE!!
After finishing the installation you must power the luminaire at least for 24 hours for
battery charging to perform the nominal autonomy.
INSTALLATION INSTRUCTIONS
Figure
3
LED MODULE CHARACTERISTICS
Manufacturer
Model Number
Voltage Range
Connections
Nominal Power
Temperature (tc)
Olympia Electronics S.A
45 °C max. across the board
Non reversible connection between main pcb and led module
8.7-10.8VDC
780mW
3105165
GR-2110/ST
GR-2100/ST
