Page
3
from
4
Mounting the lamp in suspended ceiling.
Set up the lamp to the suspended ceiling as it is shown bellow
(Required opening 110mm)
:
Step 1
Bend the springs, to get into the hole of the suspended ceiling, as you can see to the next figure.
Step 2
Push up the luminaire, as shown in figure 2.
Step 3
Continue to push upwards until the lamp locks.
If you want to pull off the device,
put a flat blade
screwdriver, between the device and the ceiling.
Figure 2
Figure 3
Figure 1
Ø110mm
923270000_09_00
4
Surface mounting
Install the luminaire according to the following steps
:
Step 1
.
Follow the step 1
of the installation instructions
.
Step 2.
Unfasten the retaining screw (Figure 4) and detach the part for suspended ceiling installation.
Step 3
.
(Figure )
Drill 2 holes on the base
5 using a 4mm drill bit in order to permit the retaining screws to
pass. Mark these two drilled points on the required mounting location, drill the holes and install
the supplied plastic plugs.
ATTENTION
!!
Especially for the GR-270 and GR-272
luminaire
installation on the ceiling you must align the base with the indications on the luminaire’s base
.
Step 4
.
Install the decorative rim (package included).
Next, use the 2 fasteners to install the unit to the
require location.
Step 5.
Follow the steps 2,3 and 4 of the installation instructions.
Figure 4
Figure
5
Retaining fastener
Drill here
Indications
