923
060000
_23_01
3
Page
2 from
2
When the unit is removed from its base, the
charging stops and the unit automatically enters the
backup operation. Observe that the illumination is
automatically increased to the maximum level. To
decrease the light level, press the push button
continuously until the desired level has been
reached. By decreasing the light level, the
autonomous duration is increased.
Each time the unit enters backup operation, the
illumination level is automatically set to maximum.
If the unit is in backup operation for a time period
that exceeds the above mentioned times, then the
LEDs will go OFF in order to protect the battery
from deep discharge. In this state the unit is
completely inoperative and a complete 24 hour
charge is required until its next use.
Photo-sensor activation - deactivation
By default the photo-sensor is deactivated. This
means that the unit will light if it is in the ON state.
If the photo-sensor is activated then the unit will
light only in the dark and if it is in the ON state. To
activate or to deactivate the photo-sensor follow
the same procedure as mentioned below:
Remove the unit from the charging base. Press
the push button so the white LEDs turned OFF.
Release the button and press again continuously.
In 2 seconds the LEDs will light. Continue pressing
the push button for 6 more seconds until the LEDs
blink briefly.
If the photo-sensor function was disabled then with
this procedure it will be enabled. The same
procedure is used to disable the photo-sensor
function.
Mounting on the wall
There are two notches on the charging base which
are used to pass the mounting screws (figure 2).
Attention
- The luminaire is suitable for indoor use.
- When placing the unit on the charging base,
ensure that the charging LED lights.
- If the unit is not used for long periods of time,
leave it on the charging base in order to keep the
batteries charged.
- Do not mount the unit at a distance of less than
50 cm from a wall corner in order to avoid photo-
sensor disturbances.
- When placing the unit on the charging base, align
the pins of the unit to the respective pins on the
base and press gently. Do not exert excess force.
-
Replaced batteries must not be thrown into
trash bins. They must be returned to
special battery disposal points. Do not
incinerate.
- When the mains cable is damaged, this must be
replaced by our SERVICE department or by an
authorized technician.
NOTE!!
After finishing the installation you must power
the luminaire at least for 24 hours for battery
charging to perform the named autonomy.
If the autonomous duration time is considerably
less than nominal, the battery must be replaced
with a new one with the same type.
Battery replacement procedure
(
figure
3).
1. Detach the luminaire from its base figure 1.
2. Unfasten the 2 mounting screws of the rear
plastic and remove it.
3. Remove the battery an place a new one with the
same type and connect it as shown in the picture.
4. Refit the rear plastic and fasten the removed
screws in step 1.
50 cm
minimum
distance
Used for wall
mounting
figure
2
figure
3
2
2
3
Charging
contacts
Charging
indicator
Push
button
figure
1
